MULTIQUIP Rammax RX1575 - Unit Shutdown; Turning Off the Engine; Machine Parking

RX1575 SERIES TRENCH ROLLER • OPERATION MANUAL S/N 3069933~ — REV. #0 (11/29/23) — PAGE 57
UNIT SHUTDOWN
64 RAMMAX 1575
557046
557096
2.7 Machine control and use
2.7.5 Turning o the engine
• Switch the switch on the remote control to the “0” position.
• Turn the ignition key to the “0” position.
As long as the “Start-Stop” rocker switch is placed in the
“neutral” position, the transmitter remains operational.
Always switch o the transmitter during work breaks
and after completing work by moving the rocker switch
to the “0” position.
2.7.6 Machine parking
• Clean the Machine to get rid of any coarse dirt.
• Carry out overall inspection of the Machine and repair any
defects that occurred during operation.
• Use scotch blocks to secure the drums.
• Close and lock the protective cover.
Shut down the Machine on at and paved surface.
Conrm there is no potential of natural hazard (land-
slide, potential ooding due to any deluges, etc.) at the
location.