MULTIQUIP Rammax RX1575 - Standby Mode Functions

RX1575 SERIES TRENCH ROLLER • OPERATION MANUAL S/N 3069933~ — REV. #0 (11/29/23) — PAGE 59
66 RAMMAX 1575
2.7 Machine control and use
2.7.8 Standby mode
The machine has three dierent types of standby mode.
Standby mode 1
Activation conditions:
The engine is started.
The machine is not receiving any operating command.
Description:
The engine speed is reduced to idle after 15 sec.
Standby mode is indicated by the beacon.
Duration:
Standby mode 1 is active for 15 minutes. After 15 minutes the
motor is switched o and the machine switches to standby
mode 2.
Deactivation:
Standby mode 1 is deactivated by an operational command,
e.g. activation of steering, travel, vibration or by switching to
standby mode 2.
Standby mode 2
Activation conditions:
Key in the ignition box in the “I” position.
Engine o.
Standby mode 2 occurs after switching from standby mode 1,
or when the key is switched to the “I” position, see Chapter 2.1.3.
Description:
It is possible to start the engine and activate the warning horn.
The electric fuel pump is running.
Standby mode is indicated by the beacon.
The engine can be started in the normal way according to Chap-
ter 2.7.3.
Duration:
Standby mode 2 is active for 10 minutes. After 10 minutes the
motor is switched o and the machine switches to standby
mode 3.
Deactivation:
Standby mode 2 is deactivated by the engine start command or
by switching to standby mode 3.
Standby mode 3
Activation conditions:
Key in the ignition box in the “I” position for longer than 10 min.
Engine o.
Description:
The electric fuel pump is not running.
The beacon indication is o.
Charging of the remote control is possible for a maximum of 2
hours, after which it automatically switches o.
Duration:
The machine with a fully charged battery lasts 4 days in standby
mode (depending on battery state and ambient conditions).
After this time, it may be dicult to start the engine due to low
battery voltage.
Deactivation:
The machine must be started manually using the ignition box or
the wake-up signal.
Waking up the machine
To wake up the machine from sleep mode, switch the Start/Stop
switch to the Start position. Press and hold the dead man but-
ton for 10 sec. The machine will switch to standby mode 2.
The machine can also be started using the key in the ignition
box.
STANDBY MODE FUNCTIONS