MULTIQUIP Rammax RX1575 - Unit Overturning

RX1575 SERIES TRENCH ROLLER • OPERATION MANUAL S/N 3069933~ — REV. #0 (11/29/23) — PAGE 63
UNIT OVERTURNING
70 RAMMAX 1575
555133
555134
hours
557086
6
2.7 Machine control and use
2.7.13 Roller overturning
• If the machine is overturned, the motor will automatically
switch o.
• Raise the machine back onto the drums as quickly as pos-
sible using a crane.
• Turn the key to the 0 position, turn it o.
• The machine overturning is indicated by the machine over-
turning indicator lamp (6) on the machine display.
• Engine start is blocked and a process is required to unblock.
• Contact your dealer for unblocking.
Under no circumstances should you try to restart the en-
gine right away.
It can cause serious engine damage.
If the machine overturns, contact your dealer.
Operating uids pose a risk to the environment!
Do not allow any liquids into drains, soil or the surround-
ing environment.
Immediately prevent the spread of any liquids leaking
out, e.g. oil, diesel, antifreeze, battery acid.
2.7.12. 2D ROPS function
• The main purpose of the 2D ROPS function is to prevent the
machine from overturning.
• If the machine reaches an inclination of 15° (27%), the vibra-
tion switches o.
• An acoustic signal sounds.
• The beacon starts ashing.