Multitech MultiConnect rCell 100 Series - Device Connector Layout




UsingtheRouter’sWebInterface 8

a. TousePPP,checkEnable.Whenenabled,yourdevicefunctionsasarouter.
b. Toenablethedial‐on‐demandfeature,checkDial‐on‐Demand.Toconfigurethesettingsthatre‐
establishtheconnectionwhenDial‐on‐Demandisenabled,seeConfiguringwakeup‐on‐call.
c. IntheIdleTim
eoutfield,typetheamountofidletimetha
tpassesbeforetheroutertimesout.If
thetimeexpires,thePPPconnectiontotheInternetisdisconnected
d. IntheAPNfield,typetheAPN(AccessPointName).TheAPNisassignedbyyourwirelessservice
provider.
e. ClickNext.Orifyo
uaredonemakingcha
nges,clickFinish.
6. InthePPPAuthenticationpanel:
a. FromType,selecttheauthenticationprotocoltypeusedtonegotiatewiththeremotepeer:pap,
chap,orpap‐chap.Thedefaultispap‐chap.
b. IntheUsernamefield,typeusernamewithwhichth
ere
motepeerauthenticates.Youcanleave
thisfieldblank,ifdesired.Usernameislimitedto60characters.
c. InthePasswordfield,typethepasswordwithwhichtheremotepeerwillauthenticate.Youcan
leavethisfieldblank,ifdesired.Passwordislimitedto60characters.
7. ClickFinish.