Multitech MultiConnect rCell 100 Series - Installation and Operation Guide; Connecting the Router; Antenna Diversity Feature




UsingtheRouter’sWebInterface 19

SettingupWi‐Ficlient
AsanalternativetofunctioningasaWi‐FiAccessPoint,yourroutercanfunctionasaWi‐FiClient.
1. FromWireless,selectWi‐FiClient.
2. ToallowtheroutertoactasaWi‐Ficlient,checkEnabled.
3. FromtheClientModedrop‐downlist,selectoneofthefoll
owing:
 WAN
 LAN
4. ClickSubmit.IfWi‐FiAccessPointfeatureisenabled,youareaskedforpermissiontodisableitbefore
proceeding.
5. After30to60seconds,clickRefresh.Afterafewseconds.alistofdetectedWi‐FiAccessPointsappears
intheAvailableNetworksgroup.
6. IntheAvailableNetworksgr
oup,clicktheSSIDfortheWi‐FiAccessPointyouwanttouse.TheAdd
SavedNetworkdialogboxopens.
7. Reviewtheinformation,enteranyrequiredsecurityinfo,thenclickFinish.TheWi‐FiAccessPointyou
justaddedappearsintheSavedNetworksgroup.
8. Ifdesired,addadditionalAc
cess
PointstothelistofSavedNetworks.Theroutertriestoconnectto
SavedNetworksintheordertheyarelisted.Youcanchangetheorderbyclickingtheupordownarrows
shownunderoptions.
9. Whendone,clickSubmit,thenSaveandRestart.
10. The
Statusfielddisplays"Connected"ifyouhavesuccessfullyconnectedtotheWi‐FiAccessPoint.
Settingupbluetooth
TheBluetooth‐IPfeatureallowsadataconnectionbetweenaremoteTCP/UDPclientorserverandalocal
Bluetoothdevice.
TosetuptheBluetoothconnection:
1. Toenablethefeature,checkEnabled.ClickSubmit.