Operation Instructions Spitfire 65/90 Extreme
CHAPTER 2 : PRODUCT OVERVIEW
13 AP-77140 – Rev. 1.1 – 05/04/07
2 PRODUCT OVERVIEW
2.1 PART NAMES AND FUNCTIONS
Part names and functions are explained below.
2.1.1 Front
No Name Function
1
Heater plate Supports and heats the media during printing.
2
Front cover
Keeps the operator safe from the drive parts of the printer while it is
operating. Only open and/or close the cover to perform following
operations:
• Media setting and replacement
• Cutter blade replacement
• Cleaning the cleaning wiper
3
Carriage Drives and holds the print heads.
4
Operation panel To control the printer.
5
Ink compartment cover Covers the ink compartment.
6
Stand Carries the main body.
7
Waste bottle assembly Collects the waste fluid.
8
Winder
*
Rolls up the roll media.
9
Front tension system Keeps the media under tension.
10
Left maintenance covers Covers the maintenance areas.
*
Only a 90” model comes standard with an Unwinder/Winder 100 system. For a 65” model, one has to choose between a Tensioning winder 30 or an Unwinder/Winder 100.
To Next Page
Loading...
