Operation Instructions Spitfire 65/90 Extreme
CHAPTER 5 : PREPARATIONS BEFORE PRINTING
55 AP-77140 – Rev. 1.1 – 05/04/07
5.2.3 Helpful tools for setting the step
The step can be set / changed in two different ways:
• Using the enclosed DVD
• Via the printer interface
Notice that your step will be set more precisely when using the files on the DVD instead of the ones
embedded in the firmware.
5.2.3.1 Using
the DVD
Step 1 : Insert the “GET STARTED WITH…” DVD (auto start-up)
Step 2 : Follow the complete procedure described on the DVD until no overlap or gaps are visible in the
pattern.
Step 3 : Afterwards print the pre-ripped print file on Mutoh’s One-in-ALL vinyl for verification
To Next Page
Loading...
