157
15
16
1
2
hyperion X5 3D CEPH/CEPH Ready - TECHNICAL MANUAL
EN
DEVICE INSTALLATION AND CALIBRATION » 3D calibration
When passing from one FOV to the next, remove the tick from “Enable Manual Tuning” to allow the
collimator to reposition itself according to the chosen FOV.
4.7.2 BLANK ACQUISITION AND DAILY CHECK
IMPORTANT: If requested by the customer, select menu “Tools-->Force always use dead man button for
automated procedure” to force the use of ray button both for Daily Check and for Blank Acquisition.
To Next Page
Loading...
