Myray hyperion X5 3D CEPH - Freestanding Base

214 pages

Save Page as PDF

To Next Page

To Previous Page

±h

CEPHCEPH

NO CEPHNO CEPH

CEPHCEPH

NO CEPHNO CEPH

hyperion X5 3D CEPH/CEPH Ready - TECHNICAL MANUAL

DEVICE INSTALLATION AND CALIBRATION » Assembly instructions

4.1.3 FREESTANDING BASE

For further information, see the supplied

INSTALLATION DIAGRAM.

Main Page

Table of Contents5
General Warnings7
Foreword7
Safety Instructions7
Packaging and Handling11
Handling and Storage11
Damage During Shipment11
Preinstallation13
Device Installation and Calibration15
Assembly Instructions15
Removal of Packaging15
Wall Mounting16
Freestanding Base17
Wall-Mounted Column18
Cinematic Group Installation21
CEPH Arm Installation (if Present)30
Check During the Assembling34
Checking after Mechanical Installation34
Cover Installation35
Covers Removal41
Operating System Configuration43
System Requirements43
Preliminary Operations43
Operating System Settings43
Power Management Settings44
Operating System Optimization Settings46
Disabling "Windows Auto-Update Service48
Disabling Windows Update Sharing over the Network (Low Data Traffic)49
Firewall Settings, Privacy and Security49
Windows Defender" Settings50
Device Installation Settings52
PC-Device Connection55
Case 1 - Device-PC Direct Connection (Setting a Static IP Address on the Network Card)55
Case 2 - Device-PC Connection over the Network (Setting a Dynamic IP Address on the Network Card)56
Configuration of "Intel®" Network Card for Sensors58
Software Installation61
Acquisition Server Plus" Software Installation61
CBCT Panel Installation63
Acquisition Server Plus" Configuration63
Device Search and Connection65
Sensor Search and Connection69
Pleora Driver Installation73
Driver Installation Checks79
Irys Software Installation and Configuration81
Calibration91
Tube Head Warm-Up91
Preliminary Actions94
Machine Configuration96
PAN Verify X-Ray Alignement99
PAN Verify Sensor Calibration109
PAN Verify Mechanical Centering111
Laser Calibration115
CEPH Verify X-Ray Alignment119
Manual Regulation of the Secondary Collimator128
CEPH Verify Sensor Compliance133
CEPH Verify Sensor Calibration136
CEPH Verify Mechanical Centering138
Headrest Calibration143
Nasion Calibration147
Backup Calibration Data to File149
Aligning the Ear Guide Rings151
Calibration155
Beam Limiter Test155
Blank Acquisition and Daily Check161
Cylindrical Test Phantom Acquisition ("Mattarellum")165
Calibration Backup173
QA Phantom Scan (Optional)174
Control Panels and Display Symbols185
Console Onboard the Machine185
Pushbutton Panel on CEPH Arm186
Service Menu187
Circuit Boards189
Unit Block Diagram189
LOGIC Board (97661808)190
Connector List192
Diagnostic Leds192
POWER Board (97662307)194
Connector List196
Diagnostic Leds196
Brush DC (97662306)198
Connector List200
Diagnostic Leds200
CEPH Keyboard (97661913)201
Connector List202
PAN Sensor Interface (97661912)203
Connector List203
CEPH Sensor Interface (97661912)204
Connector List204
Panel Interface (97661579)205
Connector List206
Keyboard (97661484)207
Connector List207
Connectivity209
Sensors / 3D Panel IP Address Amendment209
Firmware Upgrade209
Device Firmware Upgrade209
Sensors Firmware Upgrade210
Remote Support213

Myray hyperion X5 3D CEPH - Freestanding Base

Table of Contents

Related product manuals