Myray hyperion X5 3D CEPH - Operating System Configuration; System Requirements; Preliminary Operations; Operating System Settings

39
1
2
3
hyperion X5 2D CEPH/CEPH Ready - TECHNICAL MANUAL
EN
DEVICE INSTALLATION AND CALIBRATION » Operating system conguration
4.4 OPERATING SYSTEM CONFIGURATION
4.4.1 SYSTEM REQUIREMENTS
The device works with 2 Ethernet connections, one for generic communication with the PC (that can be connected to a
local area network) and another one (which must absolutely be point-to-point) dedicated to image acquisition from the
3D panel, therefore connecting the device to the INTEL GIGABIT network card of the computer.
The computer dedicated to image acquisition must have MANDATORY requirements. Refer to the manual “97055016
- Minimum and recommended system requirements” for the specications. Refer to the same manual for the
minimum requirements of the pc clients not directly connected to the machine.
4.4.2 PRELIMINARY OPERATIONS
The PC supplied by Cea is complete with hardware and software for the device operation. If another PC is chosen, it
must comply with the specic requirements and the software must be installed on it autonomously.
The PC connected to the device needs an account with the administrator rights.
WARNING: for the video card drivers, use the pack available on the Extranet.
4.4.3 OPERATING SYSTEM SETTINGS