Nabco GT20 Wire And Programming Manual

23 of 43
www.NabcoEntrances.com GT20 Wire and Programming Manual
Rev 5-7-18 P/N C-00140
b. Choose between Europe/USA
Region
EU
Region
EU
Region
USA
2. Move the Joysck up or down. The Element will stop blinking and be right side up for each circumstance.
Region
US
3. Briey push down on the Joysck. The Value will start to blink on the lower half of the screen.
4. “Rod” communicates to the Control what type of Arm is being used and whether it is inswing or outswing. Move the Joysck
to the Right or to the Le to select(1) of the following Values.
Rod
STD-PH
Rod
SLI-PL
Rod
SLI-PH
Rod
WIN-PH
Rod
DIR-PH
Rod
DIR-PL
Rod
OHC-PH
Rod
OHC-PL
5. Briey push down on the Joysck to (OK) selecon.
6. dAxis is the distance in inches between the Back Plate of Header to the Centerline of hinge. Move the Joysck Down unl the
Element dAxis is displayed.
dAxis
2.8 in
7. Briey push down on the Joysck. The Value will start to blink on the lower half of the screen.
8. Move the Joysck to the Right or to the Le to select(1) of the following Values: 0cm...25cm
a. dAxis is an approximate Value. The installaon may have to be adapted accordingly.
DN 1181
Centerline of Door Pivot
or Hinge
dAxis
Moun ng Plate (op on)
+
—
dAxis
+
—
1 cm = 3/8 inch
2 cm = 3/4 inch
3 cm = 1-3/16 inch
4 cm = 1-1/2 inch
5 cm = 2 inch
6 cm = 2-3/8 inch
Figure 4 
9. Ao is the opening angle of the door. The default is 95 degrees. Move the Joysck Down unl the Element A0 is displayed.
Ao
90°
10. Briey push down on the Joysck. The Value will start to blink on the lower half of the screen.
11. Move the Joysck to the Right or to the Le to select(1) of the following Values: 20°...190°
12. Briey push down on the Joysck to (OK) selecon.
13. Move the Joysck Down unl the Element LowEn is displayed.
LowEn
OFF
14. Move the Joysck to the Right or to the Le to select(1) of the following Values.
LowEn
OFF
LowEn
ON
DO NOT USE

Nabco GT20 Specifications

General

Brand	Nabco
Model	GT20
Category	Door Opening System
Language	English