EasyManuals Logo

Nabco GT20 Wire And Programming Manual

Nabco GT20
43 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
29 of 43
www.NabcoEntrances.com GT20 Wire and Programming Manual
Rev 5-7-18 P/N C-00140
Element
Unit Type Default Value Description
Inverse Full & Low OFF OFF...ON In the event of a power failure/error, the Door Panel is opened by spring power
from any posion (unless it has been locked). The posion of the motor connector
is reversed with regard to the standard drive unit.
Teach must be acvated aer this seng has been changed.
dAxis Full & Low 7in 2...25IN Distance between center line of the door hinges and the mounng surface of the
Operang Assembly. dAxis is an approximate value. Depending on the installaon
situaon, dAxis may have to be esmated.
Teach must be acvated aer this seng has been changed.
Table 11 
Element
Default Value Description
APuGO OFF OFF,
2°...10°
Triggering angle for Push&Go (angle push&go).
ASES 95° 45°...95° Lock out angle:
X Angle at which swing side door mounted sensor is ignored just before open.
X If Ao is changed, ASES is auomacally set to Ao.
ASER 0°...60° Lock out angle:
Angle at which push side door mounted sensor is ignored just before closing.
inac ve
DN 1188
closed
ASES
closed
SES
open
ASER
SER inac ve
Element
Default Value Description
SESClo INACTIVE ACTIVE Sensor mounted on Swing side of Door Panel is acvated or inacvated during closing cycle.
INACTIVE
EMY-IN CL-SPR Conguraon of the Emergency terminal (break contact) (emergency input)
CL-SPR Spring Close (Standard Applicaon)
STOP Stops Door Panel Closing/Opening
OPEN Opens Door Panel
CL-MOT Motor Close (Inverse Applicaon)
OExSTp OFF OFF N/A X Used to set one of the acvaon "Values" to
“sequenal” mode.
X Sequenal mode is used to hold the door open unl a second
acvaon is received.
X One acvaon opens the Door Panel and a second acvaon is
required to close the Door Panel.
OEI Opening
Element Inside
OEO Opening
Element Outside
KEY Opening
Element NIGHT
RADIO N/A
UNLOCK PERMAN IMPULS When the Door Panel is rst open: Momentarily unlocks Electric Lock.
PERMAN When the Door Panel is rst open: Permanently unlocks Electric Lock.
EL-Fb OFF OFF Electric Lock status feedback.
N.O. Open if unlocked (-); Closed if locked (+)
N.C. Open if locked (+); Closed if unlocked (-)

Other manuals for Nabco GT20

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nabco GT20 and is the answer not in the manual?

Nabco GT20 Specifications

General IconGeneral
BrandNabco
ModelGT20
CategoryDoor Opening System
LanguageEnglish

Related product manuals