Table of Contents
1
Table of Contents
Chapter 1 Outline
1.1 What is EtherNet/IP? .................................................................................................................. 1-1
1.2 EtherNet/IP of this controller....................................................................................................... 1-2
1.2.1 I/O signals...........................................................................................................................1-2
1.2.2 Performance table .............................................................................................................. 1-3
1.2.3 Hardware configuration ...................................................................................................... 1-3
1.2.4 Hardware settings............................................................................................................... 1-4
1.2.5 EtherNet/IP network ........................................................................................................... 1-4
Chapter 2 Needed Parts
2.1 Needed Parts .............................................................................................................................. 2-1
Chapter 3 Signal allocation
3.1 Field bus I/O signals ................................................................................................................... 3-1
3.1.1 When software PLC is enabled .......................................................................................... 3-1
3.1.2 When software PLC is disabled.......................................................................................... 3-1
3.1.3 Assigning signals beyond the number of channels ............................................................3-2
3.2 EtherNet/IP signal assignment ................................................................................................... 3-2
Chapter 4 Setting
4.1 Setting procedure ....................................................................................................................... 4-1
4.2 EtherNet/IP slave settings .......................................................................................................... 4-3
4.2.1 Fieldbus settings................................................................................................................. 4-3
4.2.2 EtherNet/IP (slave) settings................................................................................................ 4-4
4.3 EtherNet/IP master settings........................................................................................................ 4-5
4.3.1 Fieldbus settings................................................................................................................. 4-5
4.3.2 EtherNet/IP (Master) Settings.............................................................................................4-6
4.3.3 Setting of scan list .............................................................................................................. 4-7
4.4 Change of the Network Environment........................................................................................ 4-22
4.4.1 Resetting of the fieldbus and EtherNet/IP (master and slave) ......................................... 4-22
4.4.2 Resetting of Scanlist......................................................................................................... 4-23
4.5 Fieldbus Channel Monitor......................................................................................................... 4-28
4.6 Output signal “Fieldbus acting correctly” .................................................................................. 4-29
4.7 Error check delay for EtherNet/IP............................................................................................. 4-30
Chapter 5 Error Detection
5.1 Error Detection on EtherNet/IP module ...................................................................................... 5-1
5.2 Error Detection on this Controller ............................................................................................... 5-3
5.3 Detailed Field Bus Error Settings ............................................................................................... 5-4
To Next Page
Loading...
