Nachi FD - Chapter 5 Error Detection; Error Detection on EtherNet;IP module

5.1 Error Detection on EtherNet/IP module
5-1
Chapter 5 Error Detection
5.1 Error Detection on EtherNet/IP module
The current status of HMS EtherNet/IP module is indicated using up to four LEDs.
LED Dip switches Cable connector
LED2
LED3
LED1
LED4
Fig. 5.1.1 HMS EtherNet/IP module
Each LED indicates the following status for the slave module.
・LED1: Network reception status
・LED2: Current module status
・LED3: Current communication status
・LED4: Scanner status
Table 5.1.1 LEDs and field bus base board Status for the Slave Module
LED Color Status Description
Green Lit Online －
LED1
－ Unlit Offline －
Green Lit Run State Currently communicating with scanner
Green Flashing Not set / Idle State
Settings are not complete or no communication with
scanner
Red Flashing Error Non-critical error detected
Red Lit Error Critical error detected
LED2
－ Unlit － No power supply
Green Lit Online / Currently connected Online
Green Flashing Online / Not connected Online / No communication partner
Red Lit Error Fatal error detected (duplicate IP address, etc.)
Red Flashing Error Non-critical error detected
Red green Flashing Self-diagnostics Currently performing self-diagnostics
LED3
－
Unlit － Initialization incomplete / No power supply
LED4 Green Flashing Packet sending and receiving Currently sending and receiving the packet