NAiS FP Series User Manual

FPΣ
Installation and Wiring
5-8
When using the flat type mounting plate (AFP0804)
Use M4 size pan-head screws for attachment of the flat type mounting plate and install
according to the dimensions shown below.
60.0 mm/
2.36 in.
Figure 32: FPΣ Installation-optional flat type mounting plate
Raise the expansion hooks on the top and bottom of the unit.
Align the expansion hooks with the mounting plate and press the hooks on the top and
bottom.
RemovalInstallation
Figure 33: FPΣ Installation using flat type mounting plate
An unit with an attached flat type mounting plate can also be installed sideways on a
DIN rail.
DIN rail
Figure 34: FPΣ Installation on DIN rail using flat type mounting plate
Note
The flat type mounting plate (AFP0804) should be used only with
the control unit as a stand-alone unit. It should not be used when
the control unit is being used in combination with an FP0
expansion unit or FPΣ expansion unit.

NAiS FP Series Specifications

General

Brand	NAiS
Model	FP Series
Category	Controller
Language	English