NAiS FP0-C32T

Installation
FP0
6-5
Matsushita Automation Controls
6.2 Important Notes
6.2 Important Notes
Please, read the following notes carefully before the installation of your FP0.
.
Notes
D
Avoid installing the unit in the following locations:
- Ambient temperatures outside the range of 0
q
Cto55
q
C/32
q
F
to 131
q
F
- Ambient humidity outside the range of 30% to 85% RH
- Sudden temperature changes causing condensation
- Inflammable or corrosive gases
- Excessive airborne dust or metal particles
- Benzine, paint thinner, alcohol or other organic solvents or
strong alkaline solutions such as ammonia or caustic soda
- Excessive vibration or shock
- Direct sunlight
- Water in any form including spray or mist
D
Avoid noise interference from the following items:
- Influence from power transmission lines, high voltage
equipment, power cables, power equipment, radio
transmitters, or any other equipment that would generate
high switching surges
- If noise occurs in the power supply line even after the
above countermeasures are taken, it is recommended to
supply power through an insolated transformer, noise filter,
or like
.
.
next page