Trial Operation
FP0
9-4
Matsushita Automation Controls
9.2 Turning the Power ON
9.2 Turning the Power ON
After checking the items given in the previous page, perform the trial operation by
following procedure.
Procedure:
1. Before turning ON the power, check the items
described on the previous page
2. Turn ON the power
3. Check that the control unit’s PROG. LED is ON
4. Enter the program
When using a programming tool, perform the operation “Clear Program”
before inputting. Enter the program using NPST-GR software or the FP
programmer
II
Ver.2. Use the proramming tool’s “total check function” to
check for syntax errors.
5. Check output wiring
Use the forced output function to check the output wiring.
6. Check input wiring
Check the input wiring by watching the ON/OFF status of the input state
LEDs or by using the monitoring function of the programming tool.
7. Switch the mode switch from PROG. to RUN mode
8. If the RUN LED turns ON, check the operation of the
program
9. Edit the program (debug) if necessary
If there is an error in the operation, check the program using the monitoring
function of the programming tool. And then correct the program.
10. Save the edited program
We highly recommend to save the created program onto a floppy disk.
To Next Page
Loading...
Need help?
General
