Chapter 7
Wiring
7.1 Safety Instructions 7 - 3.......................
7.1.1 Interlock Circuit 7 - 3..................
7.1.2 Emergency Stop Circuit 7 - 3...........
7.1.3 Start Up Sequence 7 - 3...............
7.1.4 Momentary Power Failures 7 - 4........
7.1.5 Protecting Power Supply and
Output Sections 7 - 4..................
7.2 Wiring the Power Supply to the Control Unit 7 - 5.
7.3 Grounding 7 - 7...............................
7.4 Input Wiring 7 - 8.............................
7.4.1 Sensors 7 - 8.........................
7.4.2 LED-Equipped Reed Switch 7 - 9.......
7.4.3 Two-Wire Type Sensor 7 - 9............
7.4.4 LED-Equipped Limit Switch 7 - 10.......
7.5 Output Wiring 7 - 11...........................
7.5.1 Protective Circuit
for Inductive Loads 7 - 11..............
7.5.2 Precautions for Using
Capacitive Loads 7 - 12................
7.6 Wiring the Terminal Type 7 - 13.................
7.7 Wiring the MOLEX Connector Type 7 - 15........
7.8 Wiring the MIL Connector Type 7 - 17...........
7.8.1 Contact Puller Pin for Rewiring 7 - 18....
7.9 Wiring the RS232C Port 7 - 19..................
To Next Page
Loading...
