Installation
FP0
6-10
Matsushita Automation Controls
6.5 Installation Using FP0 Flat Type Mounting Plate
6.5 Installation Using FP0 Flat Type Mounting Plate
Use M4 size pan- head screws for attachment of FP0 flat type mounting plate
(AFP0804) and install according to the dimensions shown below.
For a diagram showing detailed dimensions of the FP0 flat type mounting plate, see
*
section A.5.
Mounting panel
60.mm/2.362in.
screws
FP0 flat type
mounting plate
Procedure:
1. Raise the expansion hooks on the top and bottom of
the unit.
2. Install the FP0 unit on the FP0 flat type mounting
plate.
3. Align the expansion hooks with the plate and press
the hooks back down.
1
1
3
2
3
FP0 flat type mounting
plate
.
Notes
D
The FP0 flat type mounting plate (AFP0804) cannot be used for
an expansion unit.
.
next page
To Next Page
Loading...
Need help?
General
