Self-Diagnostic and Troubleshooting
FP0
10 - 4
Matsushita Automation Controls
10.1 Self-Diagnostic Function
10.1.1 Allowing Duplicated Output
When you change system register 20 settings (“ENAB”) using the programming
software, duplicated output is not regarded as an error and the FP0 continues to
operate.
10.1.2 Continuing After an Operation Error
When you change system register 26 settings (“CONT”) using the programming
software, the FP0 continues to operate. In this case, even if the FP0 continues to
operate, this is regarded as an error.
To Next Page
Loading...
