Table of Contents
FP0
vii
Matsushita Automation Controls
7.8 Wiring the MIL Connector Type 7 - 17....................................
7.8.1 Contact Puller Pin for Rewiring 7 - 18..............................
7.9 Wiring the RS232C Port 7 - 19..........................................
Chapter 8 Connecting the I.O.P. Display Panel
8.1 Connecting the I.O.P. D01/D30/M01/M30 8 - 3............................
8.1.1 Connection Using the RS232C Port 8 - 3...........................
8.1.2 Connection Using the Tool Port 8 - 4...............................
8.2 Connecting the I.O.P. B01/B30 8 - 5.....................................
8.2.1 Connection Using the RS232C Port 8 - 5...........................
8.2.2 Connection Using the Tool Port 8 - 6...............................
Chapter 9 Trial Operation
9.1 Before Turning ON the Power 9 - 3......................................
9.2 Turning the Power ON 9 - 4............................................
Chapter 10 Self-Diagnostic and Troubleshooting
10.1 Self-Diagnostic Function 10 - 3..........................................
10.1.1 Allowing Duplicated Output 10 - 4.................................
10.1.2 Continuing After an Operation Error 10 - 4..........................
10.2 Troubleshooting 10 - 5.................................................
10.2.1 ERROR/ALARM LED is Blinking 10 - 5.............................
10.2.2 ERROR/ALARM LED is ON 10 - 7................................
10.2.3 All LEDs are OFF 10 - 7.........................................
10.2.4 Diagnosing Output Malfunction 10 - 8..............................
10.2.5 Communication Error with Programming Software 10 - 10............
10.2.6 PROTECT ERROR is Displayed 10 - 11...........................
10.2.7 Program Mode does not Change to RUN 10 - 11....................
10.3 Error Codes 10 - 12...................................................
10.3.1 Total-Check Function 10 - 12.....................................
10.3.1.1 Syntax Check Error 10 - 12.............................
10.3.1.2 Self-Diagnostic Error 10 - 13............................
10.3.2 Syntax Check Error Codes 10 - 14................................
10.3.3 Self-Diagnostic Error Codes 10 - 15...............................
Appendix A Dimensions
A.1 Control Unit and Expansion I/O Unit A - 3.................................
A.1.1 FP0-C10RS/C10CRS/C14RS/C14CRS/E8RS/E16RS A - 3...........
A.1.2 FP0-C10RM/C10CRM/C14RM/C14CRM/E8RM/E16RM A - 3.........
A.1.3 FP0-C16T/C16CT/C16P/C16CP/E16T/E16P/E8X/E8YT/E8YP A - 4....
A.1.4 FP0-C32T/C32CT/C32P/C32CP/E32T/E32P/E16X/E16YT/E16YP A - 4..
To Next Page
Loading...
Need help?
General
