Test Mode
Troubleshooting
— Must be performed by a technician —
8B. Service
Service • Technician’s Manual
(6) Replacing the Fuse
To avoid electric shock, accidents or injuries to yourself or other people, or
damage to the electronic circuits, be sure to turn off the power switch before
starting work.
your distributor.
Remove the rear door. (See
in “8B-4-1 (4) Replacing the LCD Monitor” on page
79.)
Replace the fuse (5 A SB).
To install, perform the procedure in reverse.
Inside the Front Assembly Rear
Fuse (250 V 5 A SB)
To Next Page
Loading...
