Nasuni Edge - Changing network device and system parameters

Nasuni Edge Appliance Initial Configuration Guide 8.3 92
Overview
7. To exit the console commands, enter quit.
Important: After making any network changes, you must use the Nasuni Edge Appliance to
enter those settings so that the Nasuni Edge Appliance is consistent with the
platform. This applies to all network changes.
Changing network device and system parameters
You can use console commands to change network device and system parameters such as the
network device IP address, netmask, and MTU, as well as the system hostname, default gateway, DNS
servers, and search domains.
Important: After making any changes, you must use the Nasuni Edge Appliance to enter those
settings so that the Nasuni Edge Appliance is consistent with the platform. This
applies to all changes.
To change network device and system parameters at the console, follow these steps:
1. Access the console for the Nasuni Edge Appliance. For the Nasuni Edge Appliance hardware
appliance, use a keyboard and monitor attached to the hardware appliance. For the Nasuni
Edge Appliance virtual machine, use the virtual machine console window. The console prompt
appears.
Figure A-6: Console prompt.
2. Press Enter to access the Service menu. The login prompt appears. Enter the username and
password. The login username is service, and the default password is service. The Service
Menu appears.
Figure A-7: Service Menu.