National Instruments NI cRIO-905x Series User Manual

Buttons
Figure 2. cRIO-905x Buttons
1 2 3
4 5 6 7 8
1
2
1. RESET Button
2. CMOS Reset Button
RESET Button
Press the RESET button to reset the processor in the same manner as cycling power.
Figure 3. Reset Button Behavior
Press and hold RESET button for ≥ 5 s
Press and hold RESET button for < 5 s
Run Mode
Safe Mode
Press and hold RESET button for < 5 s
Press and hold RESET button for ≥ 5 s
Press and hold
RESET button for ≥ 5 s
Press and hold
RESET button for < 5 s
• Console Out enabled
• Network settings reset
• RT Startup App disabled
• FPGA Startup App disabled
• Console Out enabled
• RT Startup App disabled
• FPGA Startup App disabled
Safe Mode
For more information about using the RESET button for network troubleshooting, see
Troubleshooting Network Connectivity.
Troubleshooting Network Connectivity
You can use the RESET button to troubleshoot network connectivity.
Complete the following steps to reset the network adapters to default settings.
1. Hold the RESET button for 5 seconds, and then release it to boot the controller in safe
mode and enable Console Out.
2. Hold the RESET button again for 5 seconds to boot the controller into safe mode, enable
Console Out, and reset network adapters to default settings.
10 | ni.com | NI cRIO-905x User Manual

National Instruments NI cRIO-905x Series Specifications

General

Brand	National Instruments
Model	NI cRIO-905x Series
Category	Controller
Language	English