EasyManuals Logo

National Instruments NI cRIO-905x Series User Manual

National Instruments NI cRIO-905x Series
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
Type-C Device Port with Console Out. NI recommends using the USB 2.0 Type-C
Device Port with Console Out for configuration, debugging, and maintenance.
Connecting the cRIO-905x to the Host Computer Using
USB
Complete the following steps to connect the cRIO-905x to the host computer using the USB
2.0 Type-C Device Port with Console Out.
1. Power on the host computer.
2. Connect the cRIO-905x to the host computer using the USB Type C to Type A cable
(included in kit), inserting the USB Type-C connector into the USB 2.0 Type-C Device
Port with Console Out.
3. Connect the other end of the USB cable (Type-A) to the host computer.
Note The device driver software automatically detects the cRIO-905x. If the
device driver software does not detect the cRIO-905x, verify that you installed
the appropriate NI software in the correct order on the host computer as
described in Installing Software on the Host Computer in the NI cRIO-905x
Getting Started Guide.
4. Select Configure and install software to this device.
NI cRIO-905x User Manual | © National Instruments | 3

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the National Instruments NI cRIO-905x Series and is the answer not in the manual?

National Instruments NI cRIO-905x Series Specifications

General IconGeneral
BrandNational Instruments
ModelNI cRIO-905x Series
CategoryController
LanguageEnglish

Related product manuals