21
Nautilus® Pro Series Elliptical Assembly Manual
Step 14: Install Power Cord
ASSEMBLY PROCESS
14-1 Plug power cord into a 110 V, grounded (3-prong) outlet (North American model) or 220 V grounded outlet
(CE mark model). Use of extension cords or power strips is not recommended. Machine should now be
ready to use. For complete operation instructions consult Owner's Manual.
15-1 Please record the following information in case needed to assist with warranty service. Software version
is displayed briefly when unit is connected to power outlet. Serial number can be located on front
stabilizer next to A/C inlet.
Installation Date:
Installed By:
Please record the following information for future reference.
Serial Number:
Console Firmware Version:
Step 15: Serial Number Information
To Next Page
Loading...
Need help?
General
