Nautilus ONE - Page 23

Page 22
5. Remove the standard cam from the
weight engine
Fig. 63
6. Install the lever pivot using two (½ -13
UNC x 3) bolts and two (½” Internal Loc)
washers (blue).
7. Install the bumper 09-4092 and two
flanges 05-5137 if not pre-installed
(yellow).
Fig. 64
8. Attach handle weldment to pivot with
one 01-3180 bolt and 03-1035 nut. Do
not fully tighten.
Fig. 65