NComputing M300 - Server Groups Tab

NComputing M300 User Manual rev.02.21.12
Page 64 of 78
6.5 Server Groups Tab
The “Server Groups” tab allows administrators to combine several servers into a group, and then
instruct the device to connect only to servers in that group. Exactly which servers are included in a given
group and the order in which devices connect to them can be designated and altered within this menu.
When the device is setup to autoconnect to a server group, it will connect to the first available server in
the list (in the order set in the group). If the first server is not available, the device will then connect to
the next server in the group, and so on. This is a key component for using the auto-failover feature of
the L300.
UP / DOWN
Changes the order in which a server within a group will be accessed.
>> Adds a detected server to a server group.
Add Group Creates a new server group.
Add Server Adds a new server to an existing server group.
Remove Removes the selected server or group.