NComputing M300 User Manual rev.02.21.12
Page 9 of 78
GPL Declarations
The NComputing M300 access device contains – in part – some free software (software licensed in a way
that ensures your freedom to run, copy, distribute, study, change and improve the software). This free
software is also contained in the M300 firmware update files that are distributed together with
NComputing vSpace Server software installation packages that are expressly for the M300. The free
software contained within the M300 firmware includes a version of X-LOADER, U-BOOT, LINUX,
LIBSYSFS, LIBUCI, LIBUSBIP, ETHTOOL, UCLIBC, QT and BUSYBOX.
Further, for at least three (3) years from the date of distribution of the applicable product or software,
we will give to anyone who contacts us at gplcoderequest@ncomputing.com
, for a charge of no more
than our cost of physically performing source code distribution, a machine-readable copy of the
complete corresponding source code for the version of the software that we distributed to you. For
additional information refer to this page on the NComputing website:
www.ncomputing.com/gplcodedownload
To Next Page
Loading...
Need help?
General
