NCR SelfServ 34 ATM Installation Guide
B006-6590-C000 9
Fitting the Standard Collar or the ADA Collar
This section describes how to fit the standard collar with task light (walk-up or drive-up)
or the ADA collar (walk-up only).
Note: The following illustrations show a standard collar. The procedure for fitting the
ADA collar is the same.
Proceed as follows:
1. Remove the collar parts from their packaging.
Note: If a consumer mirror kit is present, replace the vertical collar moulding with the
pre-assembled mirror vertical collar moulding provided in the kit box.
2. Remove and retain the two M4 x 10 machine screws securing the lower collar
moulding to the collar assembly. Remove the lower collar moulding.
To Next Page
Loading...
