NCR SelfServ 34 ATM Installation Guide
34 B006-6590-C000
4. Connect the power cable to the socket on the AC Inlet Filter.
Note: The accessories bag can be found taped to the front of the PC module with the
power cable.
5. If you are connecting cables after installing the ATM, connect the power cable to the
AC outlet. Otherwise, leave the power cable disconnected from the AC outlet until
after the ATM is installed and bolted down.
If you have no other cables to connect, proceed to the section “Closing the Cable Entry
Hole.” Otherwise, proceed to the next section.
Connecting all Other Cables
To connect all other cables, proceed as follows:
1. Check that the mains ON/OFF switch is at the OFF position (pressed in at the 0 side).
2. Pull out the module in the security enclosure until its slides are fully extended.
3. Insert the ends of the cables through the hole in the side of the security enclosure.
4. Pull sufficient length of RS-232 (9 pin), High Order Communication and Ethernet
cables to allow them to be fed up through the security enclosure and into the top-box.
To Next Page
Loading...
