NCR SelfServ 34 ATM Installation Guide
B006-6590-C000 33
Accessing the Cable Entry Hole
Loosen the two M6 screws securing the cable entry bracket to the security enclosure. Slide
the bracket sideways to access the cable entry hole.
Power Cable
WARNING
Make sure that the power supply cable is not connected to the
AC outlet while you are connecting it to the ATM.
To connect the power cable to your ATM, proceed as follows:
1. Open both the exterior and the security enclosure of the ATM.
2. Check that the mains ON/OFF switch is in the OFF position (pressed in at the 0 side).
3. Insert the end of the power cable through the cable entry hole in the side of the
security enclosure.
To Next Page
Loading...
