NCR SelfServ 34 ATM Installation Guide
B006-6590-C000 13
Fitting the Advert Collar
This section describes how to fit the advert collar (walk-up or drive-up).
To fit the advert collar, proceed as follows:
1. Remove the collar parts from their packaging.
Note: If a consumer mirror kit is present, replace the vertical collar moulding with the
pre-assembled mirror vertical collar moulding provided in the kit box.
2. Remove and retain the two M4 x 10 machine screws securing the lower collar
moulding to the collar assembly. Remove the lower collar moulding.
To Next Page
Loading...
