NCR SelfServ 34 ATM Installation Guide
44 B006-6590-C000
iTRAN 1000 Check Processor
1. Remove the packaging from the following areas:
● Shipping bracket and screw from the front of the module.
● Foam blocks from around the module.
2. Remove the plastic latch de-activator, then pull the module out from the ATM until its
slides are fully extended. Remove the following:
● Tape from the check bin
● Tape from the capture bin
● Tape from the jam clearance latches.
3. Remove and install the endorser ribbon cassette. Instructions on how to fit the
endorser ribbon cassette can be found in the publication, iTRAN 1000 Check
Processor Operator Guide (B006-6440).
To Next Page
Loading...
