NCR SelfServ 34 ATM Installation Guide
B006-6590-C000 19
Fitting the Logo Collar
This section describes how to fit the logo collar (walk-up only).
1. Remove the collar parts from their packaging.
Note: If a consumer mirror kit is present, replace the vertical collar moulding with the
pre-assembled mirror vertical collar moulding provided in the kit box.
2. Remove and retain the logo window using the extraction tools provided. Insert the
tools into two holes at one side of the window to gently release the tabs. Apply the
same procedure on the other two holes on the other side.
To Next Page
Loading...
