NCR SelfServ 34 ATM Installation Guide
36 B006-6590-C000
9. Route the cables (RS-232 (9 pin), High Order Communication and Ethernet) through
the hole in the top of the security enclosure and out through the slot in the harness
channel frame. Then route the cables up the channel and into the PC module area, as
shown.
Note: It may be necessary to pull the module tray out of the ATM top-box to gain
easier access to the harness channel frame.
10. Ensure that there are no loose cables, and that all modules are free to rack in and out,
by, either cutting the cable to the required length, or securing inside the ATM.
11. Secure the cables to the harness channel frame, and to the top of the security enclosure
wall using the cable ties provided in the accessories bag.
12. Connect the appropriate cables to the relevant ports on the PC module.
13. Refit the side panel and top-box door.
Closing the Cable Entry Hole
1. Slide the bracket sideways to close the cable entry hole.
2. Tighten the two M6 screws to secure the cable entry bracket to the security enclosure.
Note: Make sure there is enough clearance to ensure the cables are not damaged.
3. Switch on the power at the AC outlet and then at the ATM.
4. Close the security enclosure and exterior of the ATM.
To Next Page
Loading...
