NCR SelfServ 34 ATM Installation Guide
B006-6590-C000 39
Top-Box
Open the ATM top-box and remove the piece of foam from the inside of the door.
PC Module
Remove the packaging from the following areas:
● Cable tie from the disk security latch (if fitted)
● Foam block from above the PC module and the Power supply/supplies
● All pieces of filament tape
● Remove and retain the power cable and small plastic bag taped to the module.
Module Tray
1. Remove the shipping bracket and screw from the front of the module tray.
2. Remove the tape, foam and packaging from the following modules and areas on the
module tray:
● Receipt printer - tape from the print head and paper roll. If dual roll, remove the
tape from both paper rolls.
● Journal printer - tape from the print head and paper roll
● Statement printer with paper stack:
● Tape covering the thumb screws on the paper knife
● Tape from around the hopper latch
● Statement printer with paper roll:
● Tape from around the paper tension bar above the hopper
To Next Page
Loading...
