NCR SelfServ 34 ATM Installation Guide
12 B006-6590-C000
8. Make sure that all of the collar parts are as tight as possible and that there are no
visible gaps between the collar and the facia. Secure with the two M4 x 6 machine
screws removed earlier.
9. Refit the lower collar moulding removed earlier. Locate the interlocking tabs on the
lower collar moulding with the vertical sides of the collar. Secure underneath at each
corner using two M4 x 10 machine screws.
10. Pull the ATM back against the building wall to ensure a tight fit.
11. Remove the ATM from its moving device.
12. Select an appropriate silicone sealant for the wall type and colour. Prior to applying
the sealant, ensure the joining surfaces are clean, dry and free of grime. Apply the
sealant around all the collar edges, wall and joins, ensuring there is a waterproof seal
between the ATM and wall.
13. Proceed to the section “Bolting the ATM to the Floor or Plinth
”.
To Next Page
Loading...
