NCR SelfServ 34 ATM Installation Guide
B006-6590-C000 11
6. Position the two vertical side brackets until the slots line up with the holes in the ATM
sleeve chassis, then loosely fit at each side using three M4 x 6 taptite screws. Make
sure the top collar is aligned with the ATM facia, adjusting where necessary to ensure
there are no visible gaps, before tightening all six screws.
7. Refit the two vertical collar mouldings removed earlier. Locate the interlocking tabs
on the mounting assembly with the slots on each of the vertical collar mouldings as
shown below, then slide upwards into position.
Note: If a consumer mirror kit is present, at this stage, replace the vertical collar
moulding with the mirror vertical collar mouldings according to the kit instructions.
To Next Page
Loading...
