NCR SelfServ 34 - Page 50

NCR SelfServ 34 ATM Installation Guide
46 B006-6590-C000
b Discard the bracket and replace the screws making sure they are fully tightened.
Note: When replacing the screws they must be torqued to 6.5 Nm (4.8 pound foot).
3. Pull the module out from the ATM until its slides are fully extended and remove the
packaging from the following areas:
● Tape from the check bin access door (1)
● Tape from the around the latches (2 and 3)
● Foam blocks and tape from each side of the module (5, 6 and 7)
● Remove and install the endorser ribbon cassette which can be found taped to the side
of the module. Instructions on how to fit the endorser ribbon cassette can be found in
the publication, iTRAN Scalable Check Processor Operator Guide (B006-6627).
3
2
1
4
5
6
7