Appendix
156 EasyOne Pro™ / EasyOne Pro™ LAB
Guidance and Manufacturer’s Declaration – Electromagnetic Immunity
EasyOne Pro™ is intended for use in the electromagnetic environment specified below.
It is the responsibility of the customer or user to ensure that EasyOne Pro™ is used in
such an environment.
Immunity Test IEC 60601 Test Level Compliance
Level
Electromagnetic Environ-
ment - Guidance
Conducted RF to
EN 61000-4-6
Radiated RF to
EN 61000-4-3
3 Vrms
150 kHz to 80 MHz
3 V/m
80 MHz to 2.5 GHz
3 V
3 V/m
Portable and mobile RF com-
munications equipment
should be used no closer to
any part of EasyOne Pro™,
including cables, than the rec-
ommended separation dis-
tance calculated from the
equation applicable to the fre-
quency of the transmitter.
Recommended separation dis-
tance:
d = 1.2
d = 1.2 for 80 MHz to 800
MHz
d = 2.3 for 800 MHz to 2.5
GHz
where P is the maximum out-
put power rating of the trans-
mitter in watts (W) according
to the transmitter manufac-
turer and d is the recom-
mended separation distance
in meters (m).
Field strengths from fixed RF
transmitters, as determined by
an electromagnetic site survey
a
, should be less than the
compliance level in each fre-
quency range
b
.
Interference may occur in the
vicinity of equipment marked
with the following symbol
NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is
affected by absorption and reflection from structures, objects, and people.
To Next Page
Loading...
Need help?
General
