Appendix
154 EasyOne Pro™ / EasyOne Pro™ LAB
12.7 Electromagnetic Compatibility (EMC)
Changes or modifications to the EasyOne Pro™ not expressly approved by
ndd could cause EMC issues with this or other equipment. EasyOne Pro™ is
designed to comply with applicable regulations regarding EMC. Its compli-
ance with these requirements has been verified. It needs to be installed and
put into service according to the EMC information stated as follows.
Warning
Use of portable phones or other radio frequency (RF)
emitting equipment near the system may cause
unexpected or adverse operation.
The equipment or system should not be used adjacent to,
or stacked with, other equipment. If adjacent or stacked
use is necessary, the equipment or system should be
tested to verify normal operation in the configuration in
which it is being used.
Guidance and Manufacturer’s Declaration – Electromagnetic Emissions
EasyOne Pro™ is intended for use in the electromagnetic environment specified below.
It is the responsibility of the customer or user to ensure that EasyOne Pro™ is used in
such an environment.
Emissions Test Compliance Electromagnetic Environment - Guidance
RF emissions to EN 55011 Group 1 EasyOne Pro™ uses RF energy only for its
internal function. Therefore, its RF emis-
sions are very low and are not likely to
cause any interference in nearby electronic
equipment.
RF emissions to EN 55011 Class B EasyOne Pro™ is suitable for use in all
establishments, including domestic and
those directly connected to the public low-
voltage power supply network that supplies
buildings used for domestic purposes.
Harmonic emissions to
EN61000-3-2/IEC61000-3-2
not applica-
ble
Voltage fluctuations/flicker
to EN61000-3-3/IEC 61000-
3-3
not applica-
ble
To Next Page
Loading...
Need help?
General
