EasyOne Pro™ / EasyOne Pro™ LAB 75
Performing a Test
3.10 Ending the Test
At the end of the test, push the spirette™ out of the sensor from below. Dis-
pose of it and do not reuse. Also, replace the barriette™ after each patient.
Refer to section "Hygiene, Cleaning, Maintenance, Disposal" on page 100
for sensor cleaning instructions.
Warning
Risk of Infection—
spirette™ and DLCO barriette™/FRC barriette™ are
intended for single patient use. Use new ones for each
new patient.
After tests on patients with an infection of the respiratory
tract or patients with a suspected infection of the
respiratory tract, it is recommended to clean all parts
(outside of the sensor) that were touched during the test,
before testing a new patient (see "Hygiene, Cleaning,
Maintenance, Disposal" on page 100).
3.11 Retrieving/Printing Stored Tests
EasyOne Pro™ saves all tests. Old measurements can be called up at any
time to
perform a new test with the same patient
add a spirometry trial
add a post-medication test
review or print the results.
Note
It is only possible to add a trial to a previous test that was
performed on the same day (see "Adding a Spirometry Trial"
on page 51).
Select the patient (see "Selecting/Adding a Patient" on page 41).
To Next Page
Loading...
