EasyOne Pro™ / EasyOne Pro™ LAB 7
Introduction
that information pertinent to several chapters is given only once.
Therefore, read the manual once in its entirety.
To ensure patient safety, the specified measuring accuracy, and
interference-free operation, we recommend using only original
accessories available through ndd. The user is responsible if using non-
ndd accessories.
ndd is responsible for the effects on safety, reliability, and performance
of the device, only if
assembly operations, extensions, readjustments, modifications, or
repairs are carried out by ndd or by ndd-authorized personnel
the device is used in accordance with the instructions given in this
manual.
The warranty does not cover damage resulting from the use of unsuitable
accessories and consumables from other manufacturers.
Always consult with ndd, if you intend to connect equipment not
mentioned in this manual.
Components and accessories must comply with the applicable IEC
60601 safety standards and/or the configured system must comply with
the collateral standard IEC 60601-1-1 "Requirements for the safety of
medical electrical systems".
The power cord must be an approved type acceptable to the authorities
in the country where the equipment is used.
EasyOne Pro™ must not be exposed to low temperatures during storage
and transport to avoid moisture condensation at the application site.
Wait until all moisture has vaporized before using the device. Allow the
device to reach room temperature before using it.
All publications are in conformity with the device specifications and
standards on safety of electromedical equipment valid at the time of
printing. All rights are reserved for devices, circuits, techniques, software
programs, and names appearing in this manual.
The illustrations in this manual are only examples. They are not binding
in any way.
No part of this manual may be reproduced without written permission
from ndd.
© 2012 ndd Medizintechnik AG, Technoparkstr. 1, CH-8005 Zürich, Switzer-
land
To Next Page
Loading...
Need help?
General
