Configuring Your Server 4-45
How to change setting value
On [Adapter Properties] screen, change a parameter to desired value, and then click [Submit] at the
center of the screen to determine the new value.
The status of "Battery Backup" is indicated as "Present". Clicking [Present] opens the Battery Status
screen as shown below.
IMPORTANT:
You cannot change values for "Auto Learn Period",
"Next Learn Time", and "Learn Delay Interval".
NOTES:
Status field shows "Charging" when the battery is in charged status.
It shows "Discharging" when the battery is in discharged status.
When powering on the server after replaced the battery, the Status
may not immediately change to "Charging". In that case, power on
the server for several hours, and check "Status" again.
To Next Page
Loading...
