Configuring Your Server 4-5
Memory
To pause POST if a memory error is detected
Select [Advanced] – [Memory/Processor Error] – [Halt].
To check the installed memory (DIMM) status
Select [Advanced] – [Memory Configuration] – [DIMM Group #1 - #2 Status] and check
the status indications.
To clear the memory (DIMM) error information
Select [Advanced] – [Memory Configuration] – [Memory Retest] – [Yes] and reboot the
system.
CPU
To pause POST if the system detects a CPU error
Select [Advanced] – [Memory/Processor Error] – [Halt].
To check the installed CPU status
Select [Main] – [Processor Settings] and check the status indications.
The on-screen CPU numbers and socket locations on the motherboard are associated as
shown in the figure below:
To clear the CPU error information
Select [Main] – [Processor Settings] – [Processor Retest] – [Yes] and reboot the system.
Keyboard
To set Numlock and key repeat
Select [Advanced] – [NumLock] – [On].
CPU #1 (to be installed below the heat sink)
CPU #2 (to be installed below the dummy heat sink)
To Next Page
Loading...
