NEC Express5800 1160Xd - ML (Message Log)

3-54 Service Processor
ML (Message Log)
NML MNT m b u
X X X X X
This command displays the contents of the iSP message buffer.
(The message output generated in the display operation of the message buffer is not
stored in the message buffer.)
Table 3-41. ML Display Screen
Screen Image Reference
iSPyz:---> mlENTER>
ML command displays iSP’s message log buffer.
Select interactive mode? (i[nteractive per page]/a[ll]/CR=exit) : i<ENTER>
A
***** start of message logs *******************************************
xxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
:
:
:
xxxxxxxxxxxxxxxxxxxxxx
Next ? (n[ext]/CR=exit) : n<ENTER>
B
xxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
:
:
:
xxxxxxxxxxxxxxxxxxxxxxxxxxx
Previous/Next ? (p[revious]/n[ext]/CR=exit) : n<ENTER>
C
xxxxxxxxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
:
:
:
xxxxxxxxxxxxxxxxxxx
Previous ? (p[revious]/CR=exit) : <ENTER>
D
***** end of message logs *********************************************
ML command terminated.
E
Table 3-42. ML Display Screen References
Reference Description
A Select either the mode that prompts you every page or the mode that displays the
entire buffer at the same time.
B Prompts you to respond if the next page exists.
C Prompts you to respond if the previous and next pages exist.
D Prompts you to respond if the previous page exists.
E Displays the command termination message.