3-18 Service Processor
CM (Change Command Mode)
NML MNT m b u
X X X X X
This command changes the command mode from Normal mode to Maintenance mode.
Entering Maintenance mode requires the entry of a password.
Table 3-19. CM Command Screen
Screen Image Reference
iSPyz:---> cm<ENTER>
Password is needed to enter maintenance mode.
maintenance password : xxxxxxxx <ENTER>
incorrect.
maintenance password : xxxxxxxx <ENTER>
A
Command Mode was changed to maintenance mode. B
Table 3-20. CM Screen References
Reference Description
A To switch from Normal mode to Maintenance mode, a password is required.
If you enter a
wrong password, a message is displayed and the system waits for
another password entry. If you enter an incorrect password three times in a row, the
command terminates.
Passwords are case sensitive.
B After the mode change to Maintenance mode is displayed, the command terminates.
To Next Page
Loading...
