Service Processor 3-13
SP Command Console
When you select the iSP commands on the iSP Main Menu, the SP Command Console
appears. Initially, the SP Command Console is in Normal Mode for general operation.
You can switch to Maintenance Mode (which allows all operations) by using the CM
command.
To return to the Main Menu from the SP Command Console, press ^B (CTRL+B).
Some SP commands function only on the master iSP.
Table 3-12. SP Command Console Operation
Screen Image Reference
iSP MAIN MENU
0) OS(BIOS) serial console of partition#0 (INITIALIZING )
1) OS(BIOS) serial console of partition#1 (RUNNING )
2) OS(BIOS) serial console of partition#2 (STOPPED )
3) OS(BIOS) serial console of partition#3 (FAULT )
4) OS(BIOS) serial console of partition#4 (POWER OFF )
5) OS(BIOS) serial console of partition#5 (RUNNING )
6) OS(BIOS) serial console of partition#6 (NOT CONFIGURED )
7) OS(BIOS) serial console of partition#7 (NOT CONFIGURED )
V) Virtual System Operator Panel
S) iSP commands
E) Exit
DISCONNECTALL) disconnect all console connections
iSPyz> S<ENTER>
:
:
:
:
:
<CTRL>+<B>
A
B
C
Table 3-13. SP Command Screen References
Reference Description
A When you enter S, the SP Command Console appears.
B “:” indicates the monitoring of the SP command input and SP message output.
C Pressing ^B exits the session from the SP Command Console and returns to the
Main Menu.
To Next Page
Loading...
