NEC Express5800 1160Xd - DN (Shut down System Power)

3-24 Service Processor
DN (Shut Down System Power)
NML MNT m b u
X X X
This command turns off system power (DC). If software is not running (for example, in
the S0 state), this command turns off the system.
If any software, such as the OS and BIOS, is running (for example, in the S0 state), this
command only reports a power button interrupt to the software, and the process for the
power button interrupt depends on the software. (The software may ignore the power
button interrupt, or may perform a shutdown and turn off the power.)
Even if the iSP recognizes that some software is running, the software may not be able
to process the power button interrupt due to stalling. In this case, use the DF command
to force the system to turn off.
Table 3-25. DN Screen
Screen Image Reference
iSPyz:---> dn<ENTER>
System power will be turned off if the software (OS) is NOT running.
Only power button interrupt will be generated if the software (OS) is running.
If you want to turn off the system power in any system state, use DF command.
Enter partition number (0-7/all/CR=exit) : all<ENTER>
A
Execute OK? (y/[n]) y<ENTER>
B
DN command was accepted. System power of all partitions will be turned off or power
button interrupt will be generated soon.
C
[iSPyz:INFO.ccc] partition 0 : power button interrupt.
[iSPyz:INFO.ccc] partition 1 : power button interrupt.
[iSPyz:INFO.ccc] partition 2 : power off sequence started.
:
:
:
[iSPyz:INFO.ccc] partition 2 : power off sequence completed normally.
D
Table 3-26. DN Screen References
Reference Description
A Enter a partition number.
If you select “all,” all configured partitions become the targets.
B Displays the confirmation message.
To continue, enter “y”.
C Displays the command acceptance message.
The actual process runs in the background.
D Displays the state of the process running in the background.